02-06-2023, 09:54 AM | #1 |
Registered
0
Rep 2
Posts |
X1 LED upgrade fault flickers
Hi everyone,
I recently changed the low beams and high beams on my x1 2013 to LED plug and play lights. They work fine and i have managed to remove all fault codes through bimmercode by switching the hot and cold monitoring to not active. Though despite doing all this everytime i start the engine the lights momentarily flicker and then after this they are fine. I have heard to switch off all hot/cold monitoring which i think i have done on expert mode bimmercode but i am still getting this issue when starting the engine? Any advice at all would be appreciated? Thank you |
02-06-2023, 03:15 PM | #2 |
Second Lieutenant
32
Rep 279
Posts |
You can get anti Flickr devices or resistors... this helps with the flickering. Coding only takes care off the monitoring of the current draw.
Lots available on Amazon |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|