Quote:
Originally Posted by FlashMonkey929
For the trunk and hood roundels I just got some nylon floss and a plastic pick and pushed it behind from above the pegs and another length from below the pegs. Had them go as close the center as possible and then grabbed both lengths and pulled outward. I thought about taping it off, but 🤷🏻‍♂️
|
Not a bad idea either, to be honest it’s been a really long time since I did one of these and I would’ve done it a little bit differently if I had to do it again. But the biggest thing was heat. With a little heat whatever you used to get back there is significantly easier.