[Driver72]

Last week I got my PROcede v2 installed.
In the process the female part of the power connector wire (the short wire that's bunched together with 3 other wires and shrink wrapped together) was accidently pinched and the female connector broke off.

In a quick fix, we had to resort to just pushing the male side into the wire assembly that's grouped together.

Wrapped it up in electrical tape and it works.

But it bugs me that we broke that little 5 cent connector and have it jerry-rigged and therefore it's not put together correctly.

I'd like to somehow fix the issue and put a new female connector on so I feel better about the connection.

But I'm not a wiring kind of guy.

Can anybody in So Cal help me out with this.

I'll of course treat you to lunch and a 6 pack of beers for your time.

PM me please.

For a better understanding of what wire/connector it is...
If I remember correctly It's the one in the second post on this thread, 6th picture down.
The wire with the red sleeve and blue tip that has the female connector coming out of it:

http://www.vishnutuningforum.com/for...read.php?t=284

[Terry335]

Hey Michael, if you can source the connector I can crimp/solder it on for you.