[callmehugh]

Trying to replace my turbos, but this steering rack bolt won't come off. I got the other side off like a breeze. I tried using the impact won't budgie, heating it up with propane torch too... Nothing has ran into this problem?i

[NA55]

are you using an electric impact? compressed air impact should take it off no problem.. make sure to get impact lined up as straight as possible to bolt..

[callmehugh]

Originally Posted by NA55

are you using an electric impact? compressed air impact should take it off no problem.. make sure to get impact lined up as straight as possible to bolt..

Air impact

[Ch3ss]

you might have to put a torx on the tie rod end (dont remember the size) to hold it in place and use a wrench to break the nut off. you might just be spinning the whole thing that is why the nut doesn't come off.

[sloweste9x]

Update?

[callmehugh]

Originally Posted by Ch3ss

you might have to put a torx on the tie rod end (dont remember the size) to hold it in place and use a wrench to break the nut off. you might just be spinning the whole thing that is why the nut doesn't come off.

It's not spinning at all. No movement

[callmehugh]

Originally Posted by mb21111

Update?

Is it possible for this tie rod to be reverse thread?

[DR-JEKL]

Have you tried dousing the nut in WD40 and leaving o/nite?

I've used this before with good results

[adidoman]

PB blaster works great on seized bolts

[callmehugh]

Originally Posted by adidoman

PB blaster works great on seized bolts

I used rust check