❯ Pre-defined Generic Avatars
| 03-08-2009, 03:07 PM | #1 |
|
SECDEF
123
Rep 806
Posts
Drives: 2020 X3
Join Date: May 2006
Location: Dallas, TX
|
Pre-defined Generic Avatars
I wanted to change my avitar to one of the Pre-defined Generic Avatars. Why can I only see the first page of the Pre-defined Generic Avatars in the edit avitar page? The page selection button is cut off on every computer I use.
__________________
2020 X3 xDrive30i Carbon Black/Black Vernasca Leather w/ Blue stitching
Retired: 2016 435i M-Sport Alpine White/Black Dakota Leather, 2013 328xi Melbourne Red Metallic/Black Dakota Leather, 2009 328xi Montego Blue Metallic/Saddle Brown Dakota Leather, 2006 325xi Monaco Blue Metallic/Gray Dakota Leather, 2003 325xi Steel Grey Metallic/Black Leather |
| 03-09-2009, 11:35 AM | #2 |
|
Brigadier General
 
429
Rep 4,709
Posts |
If you're looking at the first page of avatars, the page selection should be just under the cars on the right hand side, beneath the Alipine White 128 convertible.
|
|
Appreciate
0
|
| 03-09-2009, 12:50 PM | #3 |
|
SECDEF
123
Rep 806
Posts
Drives: 2020 X3
Join Date: May 2006
Location: Dallas, TX
|
My screen is cut of at the rear end of the Sedona Red Metallic 135i. I can see where it starts to say "page" but is cut off so I cannot access another page. Am I the only one with this problem? Like I said before I have tried it on 3 different computers.
__________________
2020 X3 xDrive30i Carbon Black/Black Vernasca Leather w/ Blue stitching
Retired: 2016 435i M-Sport Alpine White/Black Dakota Leather, 2013 328xi Melbourne Red Metallic/Black Dakota Leather, 2009 328xi Montego Blue Metallic/Saddle Brown Dakota Leather, 2006 325xi Monaco Blue Metallic/Gray Dakota Leather, 2003 325xi Steel Grey Metallic/Black Leather |
|
Appreciate
0
|
Post Reply |
| Bookmarks |
|
|
