[StatenEye]

Pulled this off of N54tech. Anyone built theit own and can come one confirm the size of the stock CP?

"Keep you stock diverter valves and get the Frozen boost charge pipe. Iam not sure if the stock charge pipe is 2.25" or 2.50". Clarify the size with someone else and then buy it. Go to Frozen boost .com get 1 silicone joiner with 3 meth bungs, 1 45 degree silicone coupler,1 straight coupler, and 4 hose clamps. It comes out to like $50 shipped."

[R1000K3]

It is 2.5"

[StatenEye]

Originally Posted by R1000K3

It is 2.5"

I was trying to look at your DIY but you have the photobucket passworded.

[R1000K3]

Originally Posted by medeiro

I was trying to look at your DIY but you have the photobucket passworded.

Here is a picture

[StatenEye]

Ok i bought;

Shipping Method
Standard Domestic Shipping/Handling (USPS Priority Mail: 2-3 days)
Products
1 x 2.5" Silicone Straight Coupler, Black $5.99
1 x 2.5" Silicone 45° Elbow, Black $16.99
1 x Stainless Steel Joiner with Water Injection/Probe Taps, 2.5" $9.99
4 x Stainless Steel 2.25" Worm Gear Clamp (40-63mm) $5.96

Sub-Total: $38.93
Standard Domestic Shipping/Handling (USPS Priority Mail: 2-3 days): $9.99
Total: $48.92

[R1000K3]

The 2.25" hose clamps in your list are probably too small for a thick 2.5" silicone hose. I used 70 mm clamps (see picture).

[marconi118]

Originally Posted by R1000K3

The 2.25" hose clamps in your list are probably too small for a thick 2.5" silicone hose. I used 70 mm clamps (see picture).

where did you get the material?

[Jonny550]

i just installed my FB meth elbow. You have to shave down some hose from the 45 degree bend becuase its to big but other than that it was well worth it.

[R1000K3]

Originally Posted by marconi118

where did you get the material?

Joiner frozenboost

Silicone hoses do88.se

Clamps are just STD hose clamps