FS: 1M Bi xenon LCI adaptive headlights

[hunterl41]

BIMMERPOST / Classifieds

Asking Price:

Sold

Item Interest

Selling a set of adaptive bi xenon headlights off my 1M. The headlights are in pristine condition due to the headlight protection film that is still on them, so there is no pitting or glazing of the plastic. I had them professionally removed so there are no broken tabs.

I upgraded to euro headlights and no longer need these. Price is $770 shipped in the CONUS. They will be packaged in OEM boxes my euro lights came in. They are rather large so I'm firm on price at this point, because they cost $70 to ship.

View post on imgur.com

View post on imgur.com

View post on imgur.com

View post on imgur.com

View post on imgur.com

[tomtuning]

For anyone about to go compare this to prices elsewhere -- don't, this is the best price you're going to find basically anywhere. I know because I just purchased the two cheapest LCI headlights I could find anywhere on the interwebs (in the US anyway) - both came from ebay, ended up paying around $800 all said and done. This is a WAY better deal.

You'll need to code them to your vehicle order in the BMW software suite INPA - but it takes about 20 minutes or less.

[ldimov]

What year is the 1M? Do you think that those light fit my 2011 BMW 135I with M sport package?

Thank you

[WynterFreshEVO]

Damn that is a good price!

[MightyMouseTech]

Originally Posted by ldimov

What year is the 1M? Do you think that those light fit my 2011 BMW 135I with M sport package?

Thank you

Uhhhhh.........

[tomtuning]

Originally Posted by ldimov

What year is the 1M? Do you think that those light fit my 2011 BMW 135I with M sport package?

Thank you

There was only one manufacturing year for the 1M Coupe, 2011.

They will fit your car if you have adaptive headlights and xenons. You will have to code the headlights to match your Vehicle Order on INPA. In order to get the eyebrows to work you need to run a new pin to the dead slot in PIN 7 of the headlight harness. Solder the other end of the pin wire to the wire going into PIN 1 on the harness, this wire (pin 1) powers your angel eyes.

I recently did this retrofit to my '09 135i. I purchased mismatching headlights from eBay and coded them myself with INPA.

This guide is helpful for the wiring;
http://www.1addicts.com/forums/showp...29&postcount=2

The car after the swap and eyebrow wiring done;

[hunterl41]

SOLD